NEW S3CC921 PROGRAMMER

[micro]

hi to dear mo-skin . i use this  software , but when read the chip it gives me error. this error as show on picture.thank you if you tell me whrer is problem?!!



[вложение удалено администратором]

[maisterko]

try this


[вложение удалено администратором]

[atanasssko]

поделитес плис какой хардуер там?g?
what hardware use this prog?

[micro]

maisterko .It's different software with the software that I've shown you pictures.

[Printtonerreset]

maisterko .It's different software with the software that I've shown you pictures.

For this software, the is necessary hardware.

[atanasssko]

ето крак-натая версия прога, ничего там сделат непомоч... 

[micro]

Printtonerreset and maisterko . i have hardware for this software but this software registered upload by this site can't read the chip, but demo software can read the chip. i uploaded two software with schematic hardware. you can check it and tell me why?

[вложение удалено администратором]

[maisterko]

lootoo

This schematic only works with demo software and  software which I shared with you, but will not work registered software. For registered software need special  schematic. And your schematic is works with 24cXX and AT88 chips

[micro]

do you have schematic for registered software.? if you have this schematic for registered software .thanks you

[maisterko]

do you have schematic for registered software.? if you have this schematic for registered software .thanks you

I don't have this schematic. This schematic and firmware need to buy in lapatushka