Общение > Прошивки
Проблема clp365w v3.00.02.05
surubi78:
You are not allowed to view links.
Register or LoginYou need create new fix firmware for new chip. Do not used chip.
Or read 2 dumps (spi flash and eeprom) from anoter clp365w sucessfully fixed board.
And flash these dumps to the new board.
--- Конец цитаты ---
and create 2 new fix and it did not work , I'll try the other option , then I tell you if I succeed
thank you
apopovv:
Медведь, ты аргентинца запутал вусмерть!
apopovv:
No Pasaran, Amigo!
surubi78:
You are not allowed to view links.
Register or LoginNot need to create more fixes.
Problem maybe is - possible you try to use chip(or cartrige) from already fixed printer. In this case - fix will not installed well on printer and you will get red light.
other possible thing - you was insert another cartrige for print info page. in this case in eeprom saved another crum data - and fix also will not work.
To solve this - exist 2 ways : 1st is - read eeprom (24cxxx - where xxx is model of EEPROM - i didnt remember well but think what it was 24c256) and attach dump from eeprom here. with CRUM number for which you was prepare fix firmware.
2nd way - desolder and readback SPI flash and I2C eeprom IC`s from already fixed and worked printer CLP365w and put data to proper chip from your not worked CLP365 - it also must help. But need change data in both chip once ( mean - doesnt turn onn printer for testing - until you not change the data inside each IC.)
I will read the eeprom and I will attach to analyze it
Sorry for poore English.
--- Конец цитаты ---
surubi78:
I 'm a little confused , recently gave me an clp365w 3.00.02.05 , so I'll try with these toner
Thanks for the replies
Hahaha I'm not a fan of Cristina , jajajaa
Навигация
Перейти к полной версии