Общение > Ремонт оргтехники
scx 3405F Image Error please reset printer
iohan:
does not allow me to write anything.
need to change settings here? image
[вложение удалено администратором]
iohan:
before solder jumpers not display this error (unable to oper COM8. PLEASE check your port settings). should or should not soldered jumper?
[вложение удалено администратором]
iohan:
You are not allowed to view links.
Register or Logintest converter: write any letter (symbol) from keyboard. terminal no answer
short, connect TX fnd RX pin on converter
again write any symbol from keyboard - terminal must be answer same symbol.
it work ?
--- Конец цитаты ---
I've been trying, and you can see in the picture, which appeared
. I typed TESTTEST, and wrote these symbols
[вложение удалено администратором]
apopovv:
Use short wire (10-15 cm) from converter to printer
Try 38400 or 56700 speed.
iohan:
I shortened the wires (5 cm) and I weld again.
I tried 38400 and 57600 speed but same error (unable to open COM8. Please check your port settings
. please help.
this printer is killing me
Навигация
Перейти к полной версии