Fix-free forum | Прошивки принтеров и МФУ
Общение => Прошивки => Тема начата: iohan от Март 24, 2014, 10:26:29 pm
-
Hello friends
I want to debug printer clp 365
in DOWNLOAD MODE (Eco + Power button)
with my usb ttl converter
connected TX, RX, GND (image 1)
but I have a problem.
When I load the original firmware following error appears (image 2)
Downloaded Image is not valid
Reset target and run flash writing program again.
Where I'm wrong?
(http://imageshack.com/a/img513/3597/m3vz.jpg)
(http://imageshack.com/a/img703/5831/01ok.jpg)
-
UPDATE.for CLP 365
I put spi flash memory on my programmer MiniPro TL866cs
(http://imageshack.com/a/img850/7095/ebvz.jpg)
and I programmed "ready dumps" CLP360_V3.00.01.14.bin
from here http://blog.fix-free.info/?p=775 (http://blog.fix-free.info/?p=775)
Everything went ok.
but another problem
The printer does not allow printing reports.
(http://imagizer.imageshack.us/v2/320x240q90/845/cetl.jpg)
Black toner cartridge is not compatible. Check user's guide. (appears in Easy Printer Manager).
(http://imagizer.imageshack.us/v2/640x480q90/811/iufx.jpg)
-I do not have another black chip.
- I tried to put on SPI FLASH MEMORY with the programmer, another fix firmware with another Crum , but the printer do not turn ON
What can I do in this situation?
Can be Black Crum series reading from memory chip spi flash with programmer? (how can i found black crum ?)
and then to create fixed firmware reset
or
can someone create me a fimware only with serial number (it appears in Easy Printer Manager Z6Y7BJEC7001BYH) ?
or
any other ideas are welcome.
thanks
-
UPDATE.
I found a black original chip.
I put the cartridge. result (see image)
(http://imagizer.imageshack.us/v2/320x240q90/46/vu1h.png)
I printed reports (configuration and supplies information)
BLACK Crum _12092736279
I created fixed in the printer firmware and put in FORCE MODE (download mode).
After restarting the printer again bad result.
(http://imagizer.imageshack.us/v2/320x240q90/853/8hco.png)
I loaded the original firmware again and returned to normal (with chip)
I FIX again with FIX_12092736279_CLP360_V3.00.01.14U.hd but not work.
what can be the PROBLEM?
can somebodyhelp me?
-
The chip has already been used for another printer firmware.
-
Yes. was taken from another printer reseted.
If I buy a new original chip will work?
How do I know before buying if it is original or not?