Fix-free forum | Прошивки принтеров и МФУ

Общение => Прошивки => Тема начата: acosa от Август 16, 2013, 07:59:24 pm

Название: Samsung ML-2160
Отправлено: acosa от Август 16, 2013, 07:59:24 pm

Halo. Using a FixGenOnline I create a firmware, and drag it in usbprns2. After that I can not print anything from my printer, and it said there is no cartridge installed. I can't print even supply page.
Serial is Z6RMB8GC4C00P5R, firmware v.1.20.01.05, and I can't get CRUM because I can't print anything.
Can somebody help me?

Название: Re: Samsung ML-2160
Отправлено: apopovv от Август 16, 2013, 10:36:29 pm

Try it fix http://yadi.sk/d/AlbNg6U38-47s (http://yadi.sk/d/AlbNg6U38-47s)
in FORCE!!! mode

Название: Re: Samsung ML-2160
Отправлено: acosa от Август 17, 2013, 11:39:27 am

I forget to mention, but I can't enter forced mode. Turn of printer, pres both, print screen and power button, but led want start rapidly blinking. Maybe there is some other way? Try also with both button pressed with power cable disconnected, and again connected but without any change.

Название: Re: Samsung ML-2160
Отправлено: apopovv от Август 17, 2013, 12:26:57 pm

Off printer
Press Printscreen. Hold it.
Press Power. No hold it.
After 3 sec - off Printscreen button.

In force mode - no any motor activity.

Название: Re: Samsung ML-2160
Отправлено: acosa от Август 17, 2013, 12:35:12 pm

Tell me how to send you a beer. :)
It works.
This is a real forum, where members are ready to help.
Thanks again.
Greetings from Serbia.