в debug после введения,,?,,pROBE+> ?
-----ROM monitor command format-----------
dm start_addr <byte_count>
dm.b start_addr <byte_count>
dm.w start_addr <byte_count>
dm.l start_addr <byte_count>
ESC repeat memory dump
fm start_addr byte_count byte_value
fm.b start_addr byte_count byte_value
fm.w start_addr word_count word_value
fm.l start_addr long_count long_value
pm addr byte_value
pm.b addr byte_value
pm.w addr word_value
pm.l addr long_value
cmp src1_addr src2_addr size : compare memory
memcpy source_addr dest_addr length : memory copy
ml : Automatically download and execute the ram area binary
fl : upgrade flash image
go jmp_addr
--------------
eeprom cmd arg1 arg2 arg3 arg4
gen sys_clock i2c_clock : generate prescaler and sclk value
- sys_clock : 100Mhz(0x64), 120Mhz(0x78),133Mhz(0x85)
- i2c_clock : 100Khz(0x64), 400Khz(0x190)
read dev (0: Dimm0, 1:Dimm1, 4: Main, 5: ENP, 6:WENP)
write dev offset value
read dev offset size
fill dev offset size value
--------------
pll cmd arg1 arg2 arg3
info : display pll information
calc Fin Fout : calculate M/P/S values
- Fin : Input Frequency(decimal)
- Fout : Output Frequency(decimal)
--------------
dram cmd arg1 arg2
info: check all ram dimms
memtest cmd arg1 arg2 : test memory( arg1, arg2 are hex value)
cmd : r, w, toggle, rwv, drwv,drw,dw, clear, databus
r - read as 64bit unit
w - write as 64bit unit
toggle - write toggle data as 64bit unit and then read the data a
s 64bit unit
drwv - dma write,read,verify
drw - dma write,read
dw - dma write
arg1 : burst length(0x2, 0x4, 0x8, other value is set as currnet value)
arg2 : driver strength(0x0 ~ 0x7, other value is set as currnet value)
--------------
arm cmd arg1
info : display arm core information
dc on/off : Data cache on/off
ic on/off : Instruction cache on/off
wb on/off : Write buffer on/off
mmu on/off : MMU on/off
spi.info : display serial flash info
spi.read source_addr dest_addr length flash_sel : serial flash read test
spi.dmaread source_addr dest_addr length flash_sel: serial flash read test with
dma
spi.ep source_addr dest_addr length flash_sel: serial flash erase program test
spi.ce flash_sel: serial flash chip erase test
nvram clear test_mode
0 - all nvram and memory clear
1 - memory clear
2 - backup memory clear
3 - backup main flash clear
4 - backup main eeprom clear
5 - backup network eeprom clear
6 - backup wireless network eeprom clear
format cmd
hdd : HDD will be formatted at kernel start up
flash : Backup Flash will be formatted at kernel start up
all : HDD, Backup Flash will be formatted at kernel start up
debugall : HDD, Backup Flash will be formatted and display debug message
at kernel start up
off : Cancel format at kernel start up
unzip src_addr dest_addr [count]: unzip kernel
--------------
reboot
ctrl+c : Download image