Принесли аппарат непонятно чем прошитый. При включении механика молчит, оба индикатора горят оранжевым. Наклейка V.1.01.00.22. Debug кабель есть. Лог терминала:
[ POWER ON Booting... ]
Press any key to execute Monitor Program within 1 sec...
Loading Kernel...
Kernel Reading ... Done!!
New kernel was found...
checksum is not valid(original = 0x0000A5A5, calculated = 0x0000B5A5)
Run Firmware Upgrade Mode...
Flash Data Download Address : 0x40400000
===============================
Start flash_writer
===============================
firmware source address : 0x40400018
firmware address to be written : 0x00000000
firmware size : 0x00000000
<<<0x00000000>>>
<<<0x00000000>>>
Can not find sig
Download Image from PC
{
Ready to download from Parallel/Usb/Serial (0x40400000)
-------------------------
Link ID : [4F54281A]
-------------------------
USB download<HS><HS><EPB_RX 0x00000200>
Image includes PJL(0000001B) -> Waste 80 bytes
[[512104 Bytes received]] - Complete Downloading
} /* Download End */
firmware source address : 0x40400018
firmware address to be written : 0x00000000
firmware size : 0x0007D000
<<<0x00000000>>>
<<<0x00000000>>>
checksum is valid
Found new kernel(0x40415018)!!!!
Kernel Reading ... Done!!
[ZLIB ERROR]The compressed data are corrupted or incomplete!!!
[1000022], [-8]
This is not a valid image.!!!!
Not found new kernel!!!!
Downloaded Image is not Valid
Reset Target and Run Flash Writing Program Again
