Общение > Мне нужна прошивка
Needed fix firmware for scx 3405
kasper17:
Hi Friends
Could someone generate fix firmware for my device
SCX-3405
V3.00.01.18
S/N : Z6TTB8KD6C01Q3H
CRUM 15091554138
Thanks friends
apopovv:
You are not allowed to view links.
Register or Login
kasper17:
thanx for this firmware . I istall it and works I did update my printer , after that I put tape on chip and it also works . after that I made tech mode samsung and do FC ( factory mode and than SA mode ) and aftrer that my printer stop to see any toners what is going on ??? I do this error in samsung software . I tried rewrite fix firmware but it doesn work , I tried to istall another toner but always printer didnt see it . How to solve it od how to write good firmware
<a href=https://zapodaj.net/bb45c46226082.jpg.html>error.jpg</a>
You are not allowed to view links.
Register or Login
kasper17:
Can I reflash this printer in debug mode even firmware was with protection NU or must I desolder flash ic and reprogramn it via programmer ???
And please tell me what caused that my printer stop to recognise any toner and only toner light is red. FL option from tech mode could to this and erase your fix firmware or problem is somewhere else ?
REGARDS
apopovv:
Factory Reset = remove fix activation. Your big mistake.
Solve:
- flash original FW 18 or 19 version (fix without protection)
- install another chip
- print report
- use another fix FW
Навигация
Перейти к полной версии